Motion controls DO make a difference!

Please Log In to view the details for this classified ad.

Don't have an Astromart account? Click here to create one

The Half Hitch’s motion controls deliver precise panning, centering and tracking!

The word “smooth” is too frequently applied. Sometimes the term is used to excuse an otherwise heavy feel for a mount’s movement. True smoothness requires a balanced load and low friction movements. The Half Hitch excels at these fundamentals.

The Half Hitch’s motion controls are in a class by themselves: Roller drives turning on quality stainless steel ball bearings. Like the finest focusers that employ similar drive technology, the Half Hitch’s motion controls are instantly responsive, free of backlash, and dead-on precise. For each axis, use one knob to move fast or slow — a little correction or a big sweep. And there are no clutches to adjust or locks to engage. Easy, intuitive, addictive.

One must experience the Half Hitch’s motion controls to fully appreciate how different they are from typical slow motion controls. Less versatile slow motion controls based on worm gears have both backlash and high friction. One must be traded against the other. To reduce backlash, one must increase the friction. To reduce friction, one must increase the backlash. By contrast, the Half Hitch’s motion controls respond without hesitation or slop.

Even when turning the Half Hitch without the motion controls, the movements are light, easy, and predictable. Readily accessible, no-tool adjustments allow fine-tuning the “feel” of each axis. The Half Hitch’s movements are so well mannered that you don’t need to use the motion controls to observe — but it is so nice to have them!

In addition to exceptional control, the Half Hitch delivers solid viewing. Its advanced design based upon interacting cross-braces creates an amazingly stiff assembly while being one of the lightest mounts available. And the two-axis balance adjustments mean that your scope will stay where you point it without adding friction -- even when using a bino-viewer.

Why Adding Friction Doesn't Solve Balance

Some claim that if you add enough friction into the altitude axis of a mount, then you do not have to balance your telescope. This is a bad idea for at least two reasons:
• The unbalanced load will have to be lifted against gravity when turning in one direction and will be pushed by gravity when being turned in the opposite direction. Turning the scope in one direction will necessarily feel much different than turning the scope in the opposite direction, making the scope hard to control. Basic laws of physics guarantee this condition will exist for unbalanced loads. Adding friction does not change this condition.
• High levels of friction means more force is required to start the axis turning. Not only is this large force hard to judge, the laws of physics demand that the starting force will be greater than the force required to maintain the turning motion. A jerking effect is inevitable. When trying to make small movements, this jerking affect is quite significant. Frequently, in trying to compensate, one will let the turning force drop below the required level — and the jerking effect will get repeated. Overshooting will be common, and one must reverse direction, which means one must also deal with the different feel that the axis has in one direction versus the other.
No amount of "smoothness" can overcome these two effects — especially for small centering and tracking movements. The Half Hitch eliminates these problems by making complete two-axis balancing easy and by employing true low-friction bearings to make turning forces predictable, intuitive, and controllable. Add in the Half Hitch’s positive motion controls, and you have the ticket for cosmic cruising!

The highly engineered and exquisitely built Half Hitch glides so smoothly because it starts with the correct concepts. Visit the Half Hitch website for more information on this exciting grab ‘n go mount.