I started having problems with my CG5 mount. The RA would only operate in one direction. I purchased a new hand controller and it worked intermittently. I removed the motor and was able to run it in both directions. I found the motor will run for 180 seconds and stops. This happens in both directions.
Is this a motor problem or a controller problem? Note the motor was run free with out any load.
I tried the Dec motor and it ran continually in both directions.
My question is the RA motor failing? Or is that the normal operation.
Does any one have a good motor for sale. It is the older 4 wire motor.
The only reason I asked about it may be a controller problem was I set the horizon limits on my old controller. I doubt is is a controller problem because I tried retting the old controller and it did not help and the new controller has never been set to limit the travel.
Any suggestions are appreciated.
Is this a motor problem or a controller problem? Note the motor was run free with out any load.
I tried the Dec motor and it ran continually in both directions.
My question is the RA motor failing? Or is that the normal operation.
Does any one have a good motor for sale. It is the older 4 wire motor.
The only reason I asked about it may be a controller problem was I set the horizon limits on my old controller. I doubt is is a controller problem because I tried retting the old controller and it did not help and the new controller has never been set to limit the travel.
Any suggestions are appreciated.
