Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Nexstar Hand Controller Troubles

Started by Von Eric, 04/05/2004 04:53PM
Posted 04/05/2004 04:53PM Opening Post
Help!! Long story short- I sent my Nexstar 114gt mount back to the factory for some warranty work and just recently got it back..

while the mount was away, the dog did play- and chewed the end off of my hand controller cord... When I received the mount from the factory, I repaired the cord by installing a RJ-whatever 6-prong modular phone connector... The first attempt at installing the connector resulted in no power to the hand controller- so I re-installed a connector in the opposite direction.. Now the hand control powers up... but the mount will not move at all...

Now I am unable to determine if I fried the hand controller or if the mount was simply not working upon arrival...

Any input would be greatly appreciated...

Thanks in advance- Von
Posted 04/05/2004 07:13PM #1
Von.
First the scolding then the solution:
You should never GUESS pinouts for electronics, especially power. Just because the Nexstar uses a phone type connector, doesn't mean the pinouts are right. Also if your dog chewed through it, you also need to make sure there are no shorts (do you have a multimeter?). Finally just because one end is say, ORANGE BLACK GREEN RED doesn't mean the other end needs to be wired that way...it could cross over for all you know, making for any number (well 2^n-1 anyway) possibilites for wiring, not just 2 (this way no power, okay that way, no motions). You have to be careful and get the right PINOUTS in any future electronic connector 'playing'.

Okay, scolding complete. Now the solution:
Go here (this site is your friend)
http://www.nexstarsite.com/OddsNEnds/HCExtension.htm

(the home page being ofcourse, just http://www.nexstarsite.com/)

Here you can find the right pinout and instructions on how to make your own fresh cable correctly, or you can just buy one sold as extension cables by someone there who makes them -- think of it as your chance to upgrade and get a longer cable smile

Probably better to buy one than to make your own, and please throw your old one away at this point. If Celestron fixed the mount and your dog didn't do anything nasty to the controller, then you just need to change the cable for a fresh one, not the hand controller itself, that's expensive and unnecessary.

Get yourself a new cable, and ask for help on that site before experimenting further. I'm sure it'll be fine.

All the best
TomL
Posted 04/06/2004 04:18PM #2
Thanks for the reply Bob,
I was hoping to catch someone that went through this already. I am afraid of paying greater than 60% of the cost of a new 114gt setup when it may end up being the motor control board. Well, I have been looking for a reason to upgrade... looks like this may be it...

Posted 04/07/2004 02:53AM #3
Call Celestron and tell them what happened. I would not be surprised if they help you out.

Ed York