Does anyone know of a source for something like this? Bolt it on as the "rear cell" and all SCT accessories become available. Thanks, -- William
SCT male-threaded flange?
Started by williamichang, 01/26/2005 07:31PM
Posted 01/26/2005 07:31PM
Opening Post
Posted 01/26/2005 07:34PM
#1
The closest I know of is a Borg/Hutech part:
http://www.sciencecenter.net/hutech/borg/parts/html/7424.htm
"SCT to M57/60 Adapter" - it's a thread-on part, and may need additional threaded Borg adapters.
HTH,
Eric
http://www.sciencecenter.net/hutech/borg/parts/html/7424.htm
"SCT to M57/60 Adapter" - it's a thread-on part, and may need additional threaded Borg adapters.
HTH,
Eric
Posted 01/27/2005 05:44AM
#2
Assuming you have a 2" focusser, JMI (jimsmobiledotcom) have an adapter called ADPT2THREAD that should do the trick, IF YOU HAVE ENOUGH BACKFOCUS for whatever it is you are attaching.
>>>
SCT Threaded Output Adapter—2"
Standard SCT threaded output for inserting into a 2" drawtube. This adapter duplicates the standard threads found on a small SCT allowing standard SCT accessories to be attached to the output of any 2" focuser. (This adapter is a standard accessory with an NGF-C and NGF-CM focusers). See SCT Accessories Diagram, Adapter Comparison Chart and Refractor Diagram.
ADPT2THREAD $19.95 ($6)
<<<<
>>>
SCT Threaded Output Adapter—2"
Standard SCT threaded output for inserting into a 2" drawtube. This adapter duplicates the standard threads found on a small SCT allowing standard SCT accessories to be attached to the output of any 2" focuser. (This adapter is a standard accessory with an NGF-C and NGF-CM focusers). See SCT Accessories Diagram, Adapter Comparison Chart and Refractor Diagram.
ADPT2THREAD $19.95 ($6)
<<<<
Funding Member
