Hi All,
Just a quick note of thanks to Wally and Luke (from AP) for their patience in helping me with a recent problem encountered with my AP600GTO.
A lot of my solar imaging and all of my guided shots in the past were taken via my AP900GTO, while the AP600 was normally relegated to quick setup events and not used for extended, guided imaging. During a recent session I decided to use the smaller mount, but had a devil of a time with the autoguider.
Remembering that AP has tech info posted on their site, I set about to adjust the backlash. A proper balance in RA seemed impossible to attain... anywhere near zero-backlash and I'd get a "Motor Stalled" indication?!? Opening the face-plate revealed that the RA motor was flopping in the breeze (yikes!) Better to call AP before mucking it up more!
Luke assessed my situation and patched me through to Wally, who patiently guided me through the procedure of inspecting the spur gear, removing the motor/encoder assembly, tightening the drive gear (which had loosened from the shaft), orienting and tightening the motor/encoder (which was also quite loose), and putting it all back together so that it actually ran!
)
Now for some clear skies and free time to check out this puppy with the Traveler and STL11K on some of those tiny little night time stars!
Thanks again Wally, Luke, and AP!
Paul
--- http://www.astro-nut.com ---
Just a quick note of thanks to Wally and Luke (from AP) for their patience in helping me with a recent problem encountered with my AP600GTO.
A lot of my solar imaging and all of my guided shots in the past were taken via my AP900GTO, while the AP600 was normally relegated to quick setup events and not used for extended, guided imaging. During a recent session I decided to use the smaller mount, but had a devil of a time with the autoguider.
Remembering that AP has tech info posted on their site, I set about to adjust the backlash. A proper balance in RA seemed impossible to attain... anywhere near zero-backlash and I'd get a "Motor Stalled" indication?!? Opening the face-plate revealed that the RA motor was flopping in the breeze (yikes!) Better to call AP before mucking it up more!
Luke assessed my situation and patched me through to Wally, who patiently guided me through the procedure of inspecting the spur gear, removing the motor/encoder assembly, tightening the drive gear (which had loosened from the shaft), orienting and tightening the motor/encoder (which was also quite loose), and putting it all back together so that it actually ran!
Now for some clear skies and free time to check out this puppy with the Traveler and STL11K on some of those tiny little night time stars!
Thanks again Wally, Luke, and AP!
Paul
--- http://www.astro-nut.com ---