Image of the day

Captured by
Arthur Hogan

Wizard Nebula

My Account

New to Astromart?

Register an account...

Need Help?

TV Eyepiece Question

Started by epicycle, 05/27/2004 09:36PM
Posted 05/27/2004 09:36PM Opening Post
This may have already been asked before, I couldn't seem to find it though. I have a recently new Televue Eyepiece (a few in fact). I was using one the other night and I was showing my wife an object (Comet NEAT) and she inadvertantly turned the eyepiece with a screwing motion which caused the housing that goes into the focuser (shiney part) to slightly unscrew from the body (black part). It wasn't a lot but it did freak me out a bit. Is this a bad thing. I just gently screwed it back in. It was only like 1/16 of a turn but it still loosened it up. I'd hate for that to have messed the eyepiece up and I'm sure it didn't. I would however like to know the basics of what I should be careful of and make sure doesn't happen any more. Any ideas on this?

Thanks all ...

Sean Willson
http://www.seanwillson.com/
Posted 05/27/2004 10:01PM #1
Sean,

Hug the wife...tell her everything is fine..and enjoy your new eyepieces smile

John
Posted 05/27/2004 10:01PM #2
No big deal, just tighen it with your fingers and it will be fine. In most cases the barrel does not hold the EP together.
Floyd

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 05/27/2004 10:02PM #3
I've seen a couple lose barrels on TVs, too.
It won't hurt anything. Just re-tighten by
hand. Sometimes helps to tighten - turn the
entire eyepiece - tighten again - and repeat.
I would *not* recommend glue, etc. -- if it
ever has to go in for repair or cleaning it
will make a simple job very difficult.
Posted 05/27/2004 11:26PM #4
In my expereince the barrel is not integral to the optics in Televue Plossls (15mm or 17mm).