Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

What the problem was..... (with collimating)

Started by Ron777, 07/25/2004 08:55PM
Posted 07/25/2004 08:55PM | Edited 07/25/2004 08:57PM Opening Post
Today I messed with collimating the laser again,(according to Floyds article) I did this yesterday and was so frustrated as I couldn't get repeated patterns. Today I made 8 marks around the barrel of the laser, set up a vise and used the top part of my barlow for a tube to hold the laser. I put a piece of paper on the wall about 20 feet away and carefully tuned the laser to each mark and marked a number on the paper to represent each number that it was turned to. The problem I believe is that the plastic barrel of the laser is not ROUND! It must be ever so slightly mis-shapen. Grrr. No wonder I'm always tweeking the alignment of the secondary!

Note the attatched picture. It shows the laser, the numbers I put on it, how I held it and the crazy pattern it makes when rotated. It should make a circular pattern. ( I was very careful also to tighten the set screw the same amount after each rotation.)

Do not ever buy a cheap laser!

Ron

Attached Image:

Ron777's attachment for post 17636
Posted 07/25/2004 09:09PM #1
Ron,
That really suck, cheap lasers are frustrating.
Floyd

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 07/26/2004 08:05PM #2
Ron,
Are you sure the problem is with your tube being out of round and not perhaps an issue with your v-block/vise or the arrangement of the tube inserted into the barlow? If you've got the plastic tube not properly centred in the barlow (i.e. because of the set screw and some gravity-induced slop), this could account for the beam wandering on your target paper. The pattern made by rotating the beam does seem pretty wonky though, so maybe your tube is out of round; does is wobble if you roll it on a flat table?

An alternative to the plastic tubing is the chromed drain pipe tubing (has an OD of 1.25"), so you could make a tube out of a length of this.

Best of luck!
Tim Cross