Image of the day

Captured by
Bruce Karbal

VDB 142 Elephant Trunk HOO

My Account

New to Astromart?

Register an account...

Need Help?

Coulter 13.1" Mirror

Started by bigbang, 11/30/2009 06:27AM
Posted 11/30/2009 06:27AM Opening Post
I am considering building a Dob based on a 13.1" f4.5 Coulter Odyssey 1 mirror. Does anyone have any thoughts or experience with these mirrors as regards to their 1.1" thickness? Is this a negative and how well did these mirrors actually perform?
At this point I am not concerned about the figure as I can have it refigured at some point in the future if it turns out to be "less than perfect".
I can see both positive and negative points relative to a "thinner" mirror.
The plus side...less weight and the ability to reach thermal "equilibrium" faster.
The negative side...unless one uses a well designed cell the mirror may be more prone to some "flexure" which I suppose could alter the figure/performance of the mirror.
I am not an expert on theses matters but would sure appreciate any thoughts my colleagues may have.
Thanks in advance for your thoughts!
Posted 11/30/2009 09:10AM #1
Do some homework with Google:
http://www.bpccs.com/lcas/Articles/quality.htm

IIRC the original mirror cells on these involved attaching them to
particle board disks by wrapping the circumference with duct tape,
and then using a large hose clamp to keep the duct tape in place.

You might check the success rate for people re-figuring these
mirrors. I might worry whether they were properly annealed.
Posted 11/30/2009 04:45PM #2
I have not seen a really good 13.1" Coulter mirror. Maybe they have had some, but never knew anyone that got one.

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 12/06/2009 06:59PM #3
I want to say THANKS to all for taking the time to offer their thoughts on my project!!!!!
The information provided was indeed very helpful.