Image of the day

Captured by
Bruce Karbal

VDB 142 Elephant Trunk HOO

My Account

New to Astromart?

Register an account...

Need Help?

Mounting a new focuser

Started by vct, 03/07/2009 01:40AM
Posted 03/07/2009 01:40AM Opening Post
If there is a problem when mounting a new focuser because of old screw holes, is it ok to mount the focuser a little closer or further away from the primary or is it best to go across as not to change the length?
Posted 03/07/2009 01:57AM #1
Best not to change the distance. It may create the inability to bring all your eyepieces to focus.
Posted 03/07/2009 03:05AM #2
victor truglio said:

If there is a problem when mounting a new focuser because of old screw holes, is it ok to mount the focuser a little closer or further away from the primary or is it best to go across as not to change the length?

It all depends on the focuser and whether you are happy with the current position... Do the focuser have identical heights? Can you adjust the height of the secondary mirror?

Jon
Posted 03/07/2009 04:06AM #3
victor truglio said:

If there is a problem when mounting a new focuser because of old screw holes, is it ok to mount the focuser a little closer or further away from the primary or is it best to go across as not to change the length?

Unless one or more of the new holes is tripping over an old hole (i.e., you simply cannot drill
it because the bit cannot be positioned over partial air), then you might want to try sticking to
the old focuser location. Original holes which are too big can usually be dealt with. For example,
a short sleeve over the screw so that it positions correctly in the oversized hole.

If you simply cannot use the old location, then circumferential translation is your best bet. After
all, most secondaries can rotate 360 deg. And, it won't change your focus range nor require
moving your secondary up/down the length of the ota/uta.

Dan