Sonotube Starhopper Mirror question.

Started by jonisaacs, 11/24/2006 11:45PM
Posted 11/24/2006 11:45PM | Edited 11/24/2006 11:46PM Opening Post
HiL

Look for a bit of info here.

1. I have recently acquired a couple of the older sonotube Celestron Starhoppers, one is a 6 inch, the other is an 8 inch. I like the way the trunion bearings are mounted, big aluminum dovetails that allow quick adjustment of the balance.

I had seen these back when and have heard rumours they were made by Discovery but both have a quite unique mirror and mirror cell. The mirror has a curved/spherical back and the mirrors mount with a single bolt in the center...

Anybody know the story/history on these mirrors?

Mostly just interested as they are someone different.

2. Also, the OTA's are about 52 inches long and that's about 4 inches longer than fits in my car and about 4 inches longer than they need to be. I am considering cutting the tube on the 8 incher, any suggestions on how to make a nice clean cut in SonoTube?

Thanks

jon

Attached Image:

jonisaacs's attachment for post 34587
Posted 11/25/2006 07:05AM #1
Jon, I think I would use a table saw with a fine kerf blade that had as many teeth as I could find. If you extend the rip fence vertically and build a back stop to keep the tube centered on the blade as you rotate it, you should get a pretty clean cut.

The "star" we look at tonight may have exploded millenniums ago. (To progress, we must discern what exists and what does not).
Posted 11/25/2006 07:28AM #2
Hello Jon, I've got the 8 inch model of that scope which I purchased back in 1998. I believe I spoke to Discovery a few years ago about these scopes and if my memory serves me correct, they said that they only produced mirrors for the larger versions of those scopes. The 6 & 8 inch mirrors were actually manufactured by Celestron. Luckily, the mirror in mine is extremely good - maybe not Zambuto good - but good enough to show fantastic planetary details on Mars, Jupiter and Saturn when they're well placed in moments of good seeing. While some folks didn't like the thick single vane secondary holder, I very much like that feature of my scope - no spikes shooting out of Jupiter or stars during viewing. The 8 inch tube is extra bulky, but tube currents aren't much of a problem with the design. I also like the extra tube length up at the eyepiece end as it provides additional baffling - but that sucker still fits in my car but just barely. I modified mine with ebony star on the azimuth and lined the inside of the tube with flocking paper. Good luck with the scopes - hopefully you got good mirrors as all Star Hoppers were not created equal as far as optical quality goes. I don't even want to think about it when it comes time to yank that mirror out when its time to realuminize. I do not know how bad it's going to be removing the mirror and reattaching it. Dave Sewell
Posted 11/28/2006 09:23PM #3
I have cut 10" and 14" Sonotubes using a good old-fashioned hand saw like carpenters used before they got power saws. Drew a line around the tube, laid it on the floor supported by 2x4s on both sides of the cut, and then slowly worked my way around the tube keeping the saw almost tangent to the tube. This made a nice straight, smooth cut.