Getting along nicely with the truss tubed 18 inch f-5 scope I'm building.
I have just begun polishing the big 30mm thick plate blank.
I've also been making the scope itself out of a sheet of 17mm plywood.
All cut with hand held jig the bearings are 19 inches in diameter which is adequate in my opinion.
I'm keeping the costs down by making most of it including the mirror sling spider and possibly the finder but will be using a williams optical focuser.
Will be using formica on teflon for the bearing. i hope to cut out the rocker box later this week.
As to the mirror I will be testing figuring with the mirror slung. hope to do final startesting in the scope.
note the open back i will install a fan at some stage
I have just begun polishing the big 30mm thick plate blank.
I've also been making the scope itself out of a sheet of 17mm plywood.
All cut with hand held jig the bearings are 19 inches in diameter which is adequate in my opinion.
I'm keeping the costs down by making most of it including the mirror sling spider and possibly the finder but will be using a williams optical focuser.
Will be using formica on teflon for the bearing. i hope to cut out the rocker box later this week.
As to the mirror I will be testing figuring with the mirror slung. hope to do final startesting in the scope.
note the open back i will install a fan at some stage
Attached Image: