Image of the day

Captured by
Michael Scherman

M17 Swan-Omega Celestron C6 Hyperstar2

My Account

New to Astromart?

Register an account...

Need Help?

convert a Newtonian into a Classical Cass

Started by ido, 11/01/2005 07:07PM
Posted 11/01/2005 07:07PM Opening Post
Hello,

I have a (sort of) crazy idea and yet hope it is attainable:
I want to convert a 12" f/5.3 Newtonian into a Classical
Cassegrain.

How can I drill the hole at the primary without damaging the overall figure?
Can I do that using water cut ?
What focal ratio shall I expect from this primery?

Best regards,
Ido.


http://bareket-astro.com/en.html
Posted 11/01/2005 08:26PM #1
Good day Ido, I can see you having some similar prblems I had when using an 11" F/5 primary for a Cass. May I first say though that the odds of coring a hole thru your primary(full thickness??) are not good, regardless of the method used. My 11" hole was cored than glued in before grinding/polishing. Another potential problem you will find is that the F/5 of your Newt. is slow for a cass. This will mean a longer than usual tube, and one of a cassegrains nice features is a short tube. A longer F ratio primary means not only a longer tube but the secondary is going to need a higher magnifying power to get that long light cone back thru the primary. A larger secondary can be placed closer to the primary but it would make for an usually larger than normal secondary and thats not too good either. Please note that there is an elegant solution to your situation in your message inbox. All the best on your project.