Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

focuser repair help wanted

Started by hakescl, 05/21/2003 06:28PM
Posted 05/21/2003 06:28PM Opening Post
I am trying to fix a 4" rack and pinion focuser that has ~10" of travel. This looks homemade, but I don't know if it really is. The diagonal threads on the brass rack (I guess that is the half) are getting stripped in a few places, and the whole thing is coming off from the inside of the sliding tube. (It was originally soldered, which I have been told was a bad idea.)

Questions: Should I try to "repair" it with a fine file and then make a bracket to screw it on with? Or just replace it? Does anyone make R&P sets with this much travel? (And how much would they cost?) Is there any standard for the thread spacing?

Thanks,
Charlie

Fort Lewis Observatory: (37.238, -108.052) ~2360m (7744 ft.) elevation.
Darkness - typically 6.5+
Scope - Meade 16" LX200; f6.3 focal reducer
Focus - JMI Smart focus
Camera - SBIG ST-10XE; (~.5"/pixel)
Guiding - AO-8 and/or Meade 5"/DSI/PHD
http://www.fortlewis.edu/observatory
Posted 05/21/2003 06:48PM #1
You dont need 10" of travel if you get a focuser that accepts extensions.

(For example, the AP 2.7" focuser or TMB focusers.) They both have about 4" travel, but you can screw optional full-focuser-aperture extensions in that extend the range of travel.
Posted 05/21/2003 07:43PM #2
Small Parts Inc in Miami sell racks and pinions in vearious sizes. Also Reed Tool Supply in Chicago, as well as McMaster-Carr in Atlanta.

Walt