Holes in mirror coating?

Started by AstroKwang2, 09/18/2003 11:46PM
Posted 09/18/2003 11:46PM Opening Post
Hello all,

While putting toghether a 8" Newt with a mirror coated
by Clausing (sp?), I noticed that the light from the ceiling revealed some 'pinholes' which are visible from
the bottom of the mirror. Out of curiousity, I shined a flashlight from the bottom of the mirror and about thirty to forty pinholes of light were visible on the coated side.

Is this common in a newly coated mirror? Or is it a sign of some kind of early deterioration of the coating? It was coated about 3 months ago via their "Diamond Brite" coating.

I appreciate any insights on this.

Kwang
Posted 09/19/2003 12:04AM #1
I don't know the particulars of the "Diamond Brite" coating, but it is normal for SiO2 overcoated aluminum, and yes, brand new. You want a very thin coating. A thick one will distort the figure.
--
Mike
Posted 09/19/2003 02:48AM #2
Kwang, I agree with Mike and the holes you describe are fairly normal to find in mirror coatings. If you had many more pinholes appearing in clusters it would indicate a poor vacuum was used in the aluminizing process or the mirror surface wasn't properly cleaned prior to application of the film. I don't know any particulars of the "diamond brite" coating but it's probably a variant of an enhanced coating with, perhaps, a protective coat overlying the primary coating.