Homemade EQ Platform for Dob

Started by david101, 06/19/2004 10:37PM
Posted 06/19/2004 10:37PM Opening Post
I've been considering building an Eq. platform for my dob, such as shown David Shouldice's webpage:

http://members.tripod.com/denverastro/dsdfile/dspfile.htm.

Basically I'm tired of bumping my dob for the image to stay centered, especially at higher power.

But upon further consideration, I don't want a motored version, which leads me to this point.

I want to build a platform that is a manual control for one axis. Maybe I'm thinking about a modified barndoor.

Any Thoughts ?

Sincerely

David Roberts
Posted 06/20/2004 01:08AM #1
You'll be happier with a motor. Don't forget, since you are driving the platform and not the scope, you are always free to move the scope at any time. That't the beauty of the eq platform, tirn it on and enjoy, then reset every 50 minutes to an hour later.

Walt
Posted 06/20/2004 06:33AM #2
Hi David,

The old link does not seem to work.

This one still looks good:

http://home.att.net/~dale.keller/atm/atmother/shouldice/shouldice.htm

David Simons
Posted 06/20/2004 02:54PM #3
David,
Build one! They are so convenient, inexpensive and easy to build. Here's one that I did. I used two 1/15 rpm synchronous motors driving .370 inch knurled shafts with teflon pillow blocks. The wooden sectors were done on a table saw with a sanding disk tilted to the correct angle. I adds about 5 inches to my scope but it is well worth it.
Ed Jones

Attached Image:

EL Jones's attachment for post 80722