Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Mirror Coatings

Started by fblue, 07/18/2004 10:12PM
Posted 07/18/2004 10:12PM Opening Post
I did all the testing last night and the figure seems just great, it performed right with the 15" and the 14.5" Dobs next to me. I compared images with the same EP or adjusted the focal length so the image was the same size. The 15" next to me had a 1600mm f/l and mine is 1524mm, close enough. wink
OK, I am going to send in my 12.5" mirror for re coating this week. The coatings on this mirror have a whole lot of spots on them. Looks like someone sneezed on it! grin The stuff does not come off with anything, so I am going to re coat it to bring it back to new condition.
My question is this. I can do Semi-Enhanced coatings or regular Protected Aluminum. The Semi states 93%, but in the 480-580nm range I can only see 1-2% difference in reflectivity. I am not wanting trying to keep cost down, but it seems to me that 1-2% won't amount to a hill of beans and the coast difference is $60. They use the same machine at the same temperatures for both coatings. So that is not a factor, but what do you think? I am leaning toward the Regular Protected Aluminum because of the small difference in the reflectivity.
Floyd

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 07/18/2004 10:51PM #1
I concur. Floyd. The differences are so minimal that it's not really worth it.
Your description of the mirror surface is interesting. I just had a friend bring a mirror to me that I made about 5 years ago. It looked similiar to what you describe. I put the mirror in a solution of Circuit Board Etc from Radio Shack and the coating started coming off almost immediately. Usually it takes an hour or so to see it starting to work. Something was wrong with the coating for sure.

Walt