Image of the day

Captured by
Arthur Hogan

Wizard Nebula

My Account

New to Astromart?

Register an account...

Need Help?

polishing with aluminun oxide

Started by Phil Barker, 12/05/2004 11:37PM
Posted 12/05/2004 11:37PM Opening Post
I always wondered if this would work.

As an experiment I added some 5 micron aluminun oxide to cerium and polished a mirror which had some grey near the edge and needed more fine grinding.

I did a few wets with good contact and was immediately aware of the rougher sound as I polished away.

This greatly speeds up the polishing 2 possibly 3 times as fast from what i experienced.

The grey went quickly basically i had a mirror that now didn't need any fine grinding.

A ronchi showed a rough but reasonably polished surface.

I didn't completly polish the mirror just went for 1 hour or so.

I then using the same lap which i cleaned thoroughly went to cerium and within 1 hour I could see no evidence of roughness in tests. I was well ahead of where I would be if the mirror was just polishing.

Basically this appears to be a way of speeding up polishing and if done carefully ie lap completly cleaned and returned to cerium has'nt degraded the polish at all.

Interested in comments.

Phil Barker
p.s the mirror is 16 inch f-5 and pyrex.

the lap is my own mixture 7/1 rosin and tar.

Posted 12/06/2004 11:09PM #1
Phil,
I think that's what the old-timers (me) called pre-polishing. I've never tried it but I have used 0.3 micron alumina powder for polishing hard glass types and hard stuff. It will polish faster too. It sounds like you had some success with using 5 micron but you might run the risk of getting some sleeks if you don't scrub the lap really good afterwards. I would recommend instead to use .020 urethane polishing material, you can just press it into your lap to polish it fast and when fully polished it peels off your lap easily. You then pess your lap and contine polishing. It's great stuff.
Ed

Attached Image:

EL Jones's attachment for post 85653