Image of the day

Captured by
Ruben Tommasi

Andromeda Galaxy (M31)

My Account

New to Astromart?

Register an account...

Need Help?

Re: 18" Starstructure altitude bearings

Started by fpoastro, 12/29/2003 02:26AM
Posted 12/29/2003 02:26AM Opening Post
Michael,
Do you machine all these profiles in house? Are your components tig'd together? Again, in house? Just wondering. I notice most all of the profiles you have posted are coarse sanded.

Was just wondering if you sub out your parts. Would you ever consider lacing a part like this to dump even a bit more weight?

I had a funny thought when I was looking at your images you have posted recently. I am not sure if anyone remembers but back in the early days of BMX stunt riding there were guys charging their frames with helium and seeing marked improvement even given the very small volume.

Mark
Posted 12/29/2003 11:00PM #1
Michael,
Thanks for the reply, I asked simply because of the complex shapes and profiles. I wasnt sure if you were having them cut (edm, etc) by an outside source. Its usually cheaper that way unless you are large scale. The mig/tig issue was not so much a though of strength just a question in general.

I have a friend who races superstock and has recently build a dragster and he often talks of the tricks you mention. A leg up is alwyas in the back of everyones mind. smile

Mark