Hi All. I am building a 13.1" dob. My rocker box is about 21" square.
The bearing sides of it are 3/4" BB ply. and the non bearing sides are 1/2" BB ply.
a) the real question:
What should the bottom be? I don't want to overbuild it, but don't want crappy performance either.
---
b) the theoretical rumination going on in the back of my mind:
Will 1/2" be fine? I was wondering since the az bearings press on 3 points and define a plane, if any sag imperceptible or perceptible really matters? Even if it does sag, does it matter since the scope will spin in az on those 3 points, period.
The bearing sides of it are 3/4" BB ply. and the non bearing sides are 1/2" BB ply.
a) the real question:
What should the bottom be? I don't want to overbuild it, but don't want crappy performance either.
---
b) the theoretical rumination going on in the back of my mind:
Will 1/2" be fine? I was wondering since the az bearings press on 3 points and define a plane, if any sag imperceptible or perceptible really matters? Even if it does sag, does it matter since the scope will spin in az on those 3 points, period.