Image of the day

Captured by
james carter

North American Nebula NGC7000

My Account

New to Astromart?

Register an account...

Need Help?

Rotating cages for a newtonian

Started by D Brown, 01/16/2007 04:28AM
Posted 01/16/2007 04:28AM Opening Post
Hi all
My group would be interested to hear from any members of this forum who have a rotating cage on their scope. My group is designing a 20 inch f4.5 and finding the design of a rotating cage difficult. (This is a first for us.) Googling the subject did not turn up much information other than some general references.

We would welcome any advice or design ideas.

Regards
Doug et al
Posted 01/17/2007 08:43PM #1
I recently completed a 20" f4.5 with a rotating secondary cage. I built the bearing by bending an aluminum angle (3/4 x 1/8) into a circle using a tool that I built. The tool employs three polyurethane keel rollers like those used on boat trailers. I pulled the bar back and forth between the rollers, slowly working it into a circle after several hours of very hard work!

The bearing ring is mounted on four pairs of roller skate ball bearings. It turns with almost no resistance at all.

The main problem I've had is that it is difficult to maintain alignment between the secondary and primary as the bearing rotates. You have to be careful that the axis of the bearing is aligned with the center of the primary mirror. I've spent a few hours adjusting the truss tubes and the alignment is pretty close at this point, but not right on.
Posted 01/25/2007 01:34AM #2
Thanks Guys
The lazy susans might do if well made, but I will need to see what we have availble here locally in Aussie land.

Bill thanks for yourpost. Your idea sounds it may be another solution. Would it be posible for you to make a rough sketch and post in on this thread?
Cheers
Doug