Image of the day

Captured by
Arthur Hogan

Wizard Nebula

My Account

New to Astromart?

Register an account...

Need Help?

Secondary - 3.1 or 3.5?

Started by pwp818, 05/02/2007 06:39PM
Posted 05/02/2007 06:39PM Opening Post
For a 16" f/4.3, who votes for a 3.1" secondary (19% obstruction) and who votes for a 3.5" (21.9%)? For a f/4.5 scope, most agree that it should be a 3.1". But at f/4.3 my calculation shows that producing only about .45 deg fully illuminated. I should add that I spend 90% of my time deep sky observing.
Posted 05/02/2007 07:33PM #1
Hello:

I vote for a 3.5". The increase in central obstruction is negligable, and people seem to worry about it too much. With a 3.5" secondary, your central obstruction (in percent) will be less than HST. The larger secondary gets you a wider fully illuminated field, and you won't be using as much of the edge of the mirror which can be bad.

Cheers
Mike
Who has a 10" mirror with a 5" secondary
Posted 05/02/2007 09:04PM | Edited 05/02/2007 09:07PM #2
By going to the 3.5" you nearly triple the fully illuminated area at 100% from .22 to .635°.
If it were a 15" I would go with the 3.1" but with the 16" I think I would go the 3.5". though it would probably not be very apparent at the EP.

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 05/02/2007 10:21PM #3
Hi:

I don't think one can say without knowing a bit more. Focuser height is important here as is the desired use for the scope.

I have been playing around with a 16 inch F/4.42 as I just finished it and will eventually move to a smaller secondary, currently the secondary is a full 4 incher.

For my scope with a 3 inch minimum focuser height and 18 inch inside ring diameter, the numbers looked similar to Floyd's. Since my scope is primarily a DSO scope the larger illuminated field of view will be my choice. When I see a reasonably priced 3.5 inch secondary pop up, I will snag it, till then the 4 incher is fine.

Jon
Posted 05/02/2007 11:41PM #4
UTA inside diameter is 17 5/8" (radius 8.8"). Add the wall and mounting board thickness of about 5/8" and a Moonlite CR2 focuser racked-in height of 1.5". That's about 10.9". Plus some focuser travel? I think that takes me beyond the 3.1", doesn't it?