Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Borg and Orion X/Y adjusters for guide scopes

Started by fblue, 05/31/2010 06:13PM
Posted 05/31/2010 06:13PM Opening Post
I recently purchased a Borg 50mm guide scope with X/Y adjuster and helical focuser. I noticed that it came with no instructions at all for the X/Y plate.
Anyone that is thinking of buying this X/T system from Borg or Orion should be made aware that there are a whole lot of Nylon adjustment set-screws that all need to be adjusted for the unit to work without a lot of play in it. The play will cause flexure if these are not set properly.
I will probably do a small article on this, but first I was wondering if anyone has purchased the Orion unit and does it come with an instructions page that explains these screws and how to adjust them? I have looked at the PDF file and it does not mention these screws.

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 06/01/2010 02:15AM #1
I will let you know about the Orion once I get it set up. I just ordered the "shortener" for my DSI PRO, so I hope to have everything set up by next week. (However, I still suspect the focuser on the 5" Meade as the weak point in this "flexible" guiding system.) Once I get the X-Y installed, I want to (somehow) get everything locked into place at a "fixed" focus and forget it...

Charlie

Fort Lewis Observatory: (37.238, -108.052) ~2360m (7744 ft.) elevation.
Darkness - typically 6.5+
Scope - Meade 16" LX200; f6.3 focal reducer
Focus - JMI Smart focus
Camera - SBIG ST-10XE; (~.5"/pixel)
Guiding - AO-8 and/or Meade 5"/DSI/PHD
http://www.fortlewis.edu/observatory