Hi,
I was asked if I could make a diagram for the light box I built. Here it is for you to use.
The Rheostat used was a standard 100 ohm unit with knob, wired inline to the negative 12v lead to the inverter for the panel. The box for it is a common project box from Radio Shack.
The Fluorescent panel I bought online for about $30 with the small inverter.
The box is 3/16" foamboad, but you could use 1/2" thick bought at a craft supply store in town.
Vellum paper was found in the same store as well as the Sticky Glue for assembly.
The Stencil making sheets were also at this store, so almost a one stop shopping situation.
Total cost was maybe $45.
I was asked if I could make a diagram for the light box I built. Here it is for you to use.
The Rheostat used was a standard 100 ohm unit with knob, wired inline to the negative 12v lead to the inverter for the panel. The box for it is a common project box from Radio Shack.
The Fluorescent panel I bought online for about $30 with the small inverter.
The box is 3/16" foamboad, but you could use 1/2" thick bought at a craft supply store in town.
Vellum paper was found in the same store as well as the Sticky Glue for assembly.
The Stencil making sheets were also at this store, so almost a one stop shopping situation.
Total cost was maybe $45.
Attached Image:
[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue
Amateur Imager
