Hi folks,
Well, I really did it this time! On the best night I've had this apparition, I decided to switch my toUcam settings from RAW mode to non-RAW. Since I haven't used this setting before, I was not sure of the settings to use. The AVIs look good...until I process them! Way too much grain. I tried lowering the contrast in Registax befor applying wavelets but to no avail. Is there any way I can salvage this information?
Any help would be appreciated.
Bryan Gumm
C-11, SV102 EDT, MX5-16 and the venerable toUcam
Well, I really did it this time! On the best night I've had this apparition, I decided to switch my toUcam settings from RAW mode to non-RAW. Since I haven't used this setting before, I was not sure of the settings to use. The AVIs look good...until I process them! Way too much grain. I tried lowering the contrast in Registax befor applying wavelets but to no avail. Is there any way I can salvage this information?
Any help would be appreciated.
Bryan Gumm
C-11, SV102 EDT, MX5-16 and the venerable toUcam
