Hi, I've collimated Celestron SCTs before, but am going to collimate the secondary of my Mewlon 250 for the first time since I received it. It's not totally out of collimation but it definitely needs it (I can see the out of focus image (in and out) out of round at 80x, I usually collimated my SCTs until based on Legault's paper at 500x or higher). My question, I know there are three sets of push pull allen head screws and you loosen one slightly then tighter the other slightly. Here's a picture of the front of the Mewlon.

I downloaded the Mewlon 300 manual from the Takahashi Which of the set of screws is the push and which is the pull (brass or silver allen head screws)? Unfortunately the manual in PDF form is missing all of the diagrams. It alos cautions not to loosen the "pull screw too much" which could cause the secondary to fall out and hit the primary! Kind of concerned there....
Any help appreciated.
Chuck

I downloaded the Mewlon 300 manual from the Takahashi Which of the set of screws is the push and which is the pull (brass or silver allen head screws)? Unfortunately the manual in PDF form is missing all of the diagrams. It alos cautions not to loosen the "pull screw too much" which could cause the secondary to fall out and hit the primary! Kind of concerned there....
Any help appreciated.
Chuck
