Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Telrad coming

Started by fblue, 09/03/2003 06:23PM
Posted 09/03/2003 06:23PM Opening Post
Well, I finally decided to buy a Telrad. I have looked through them but not owned them. I have a red-dot finder that I like. But I need something just for the DOB and the red-dot works nicely on the SCT. I get tired of readjusting it when I switch from scope to scope so I bought the Telrad.

It seems like the use of the Telrad and the 16x80mm finder together should make it easier to locate objects. Plus the software will show a Telrad reticle for locating them as well.

Hopefuly it will arrive by Friday so I can use it Saturday night. It is supposed to be a good clear night with no clouds or stormy air.

Now if I could just make up my mind on the dual rate focuser question! Still up in the air over this one.

JMI DX1 is nice but you have to change hands for gross and fine adjustments. Cost is very good though.

Moonlight cost is good and it is looking like a nice choice, but you have to use both hands with it too.

Clements focuser is very nice but pricy and needs a special mounting plate at extra cost.

Feather Touch is nice but requires special plates for collimation costing additional $70! This makes it very expensive overall.

They just resurfaced Mt. Pinos parking lot and there is much more room now for setting up! Very nice, except the new asphalt is very sticky. Watchout for ruining your carpets if you go up. This stuff sticks to shoes like glue and is hard to clean. Maybe it will be better this week. It should get better with time.
Dark skies all.

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager
Posted 09/03/2003 06:44PM #1
You probably already know this, but...

There really isn't any need to have a collimatible base plate for the Feathertouch (or any other focuser). Unless the focuser mounting board is really misaligned, the focuser can simply be shimmed with small stainless steel washers. Once it's set, collimation fine-tuning can be easily and accurately accomplished via the secondary.

Doug