Image of the day

Captured by
Ruben Tommasi

Andromeda Galaxy (M31)

My Account

New to Astromart?

Register an account...

Need Help?

Alan Adler's thermal management

Started by marcin, 09/07/2007 02:15AM
Posted 09/07/2007 02:15AM Opening Post
I was doing some research about removing a warm air layer from the main mirror surface and found this article:
http://www.pha.jhu.edu/~atolea/WAS/thermal_management_newtonians.pdf
As far as I know, most of you guys are convinced that the best way to solve this problem is pumping air upward with a fan (fans) installed behind the main mirror. The author of the article says that the better way to deal with it is to install a fan that blows across the main mirror removing warm air through vents on the opposite side of the tube. It's quite convincing. With the back fan setup, even with extra baffle right above mirror, is one able to remove the warm layer from center region of the main mirror?
What do you think?

8" f/5.9 truss tube newtonian, made from scratch 8)
Posted 09/07/2007 04:33AM | Edited 09/07/2007 04:36AM #1
I have been building the upper fans for a few years now. Here is on of my designs on a Starstructure.
The upper fan is what removes the boundary layer, the rear fan just aids in cooling the mirror and keeping the rear near the temp of the front with its fan. Otherwise the front fan alone is not a good idea, unequal cooling can effect the figure until the mirror reaches equilibrium.


Attached Image:

fblue's attachment for post 116645

[SIZE="Large"][/SIZE][COLOR="Blue"][/COLOR] Floyd Blue grin
Amateur Imager