[COLOR="Purple"]Well...not really but they look like they'll work okay.
These are the alt bearings for the long suffering 18.75" scope I'm building. Diameter is 23.25", heighth is 2" and they are 1.875" thick. The nice thing is they only weigh 2 pounds each. Adding the Ebony Star will add another couple of ounces to each. The nice Al bearings I bought weigh 10+ pounds each...too heavy for the semi-lightweight scope I'm building.
The ply is some stuff I found at the local hardware store...not exactly Baltic Birch but for the price not too bad at all. 11 plies and only a few small voids. Note the different colors of the wood. Each sheet had a lighter side and a darker side. The dark side should look nice facing out, with a very dark Ebony stain on it.
If I lean on one end with the other on the ground, there is a tiny (less than 1/8"?) bit of compression. Since the whole scope will be around 100 pounds, I think this will be okay.
I'm going to make them removeable for transport. Any suggestions on a "no tool" way to do that without having knobs sticking out?
Bill[/COLOR]
[COLOR="Maroon"]P.S. Can you tell that I was considering spoked bearings? Look at the lighter bearing and you'll see layout marks.[/COLOR]
These are the alt bearings for the long suffering 18.75" scope I'm building. Diameter is 23.25", heighth is 2" and they are 1.875" thick. The nice thing is they only weigh 2 pounds each. Adding the Ebony Star will add another couple of ounces to each. The nice Al bearings I bought weigh 10+ pounds each...too heavy for the semi-lightweight scope I'm building.
The ply is some stuff I found at the local hardware store...not exactly Baltic Birch but for the price not too bad at all. 11 plies and only a few small voids. Note the different colors of the wood. Each sheet had a lighter side and a darker side. The dark side should look nice facing out, with a very dark Ebony stain on it.
If I lean on one end with the other on the ground, there is a tiny (less than 1/8"?) bit of compression. Since the whole scope will be around 100 pounds, I think this will be okay.
I'm going to make them removeable for transport. Any suggestions on a "no tool" way to do that without having knobs sticking out?
Bill[/COLOR]
[COLOR="Maroon"]P.S. Can you tell that I was considering spoked bearings? Look at the lighter bearing and you'll see layout marks.[/COLOR]
Attached Image: