Image of the day

Captured by
Ruben Tommasi

Andromeda Galaxy (M31)

My Account

New to Astromart?

Register an account...

Need Help?

Finish Boo Boo

Started by web0178230, 08/27/2006 08:09PM
Posted 08/27/2006 08:09PM Opening Post
[COLOR="Purple"]In keeping with the constant theme for the 18.75" ATM project of doing everything multiple times, I'm now trying to salvage the USA (Upper Support Assembly) after applying the poly spray on finish yesterday. Dummy me had used a Sharpie marker to blacken the rings. Unfortunately, something in the Sharpie chemistry does not play well with poly. I sparayed several coats on the entire assembly before I noticed that the areas where I used the Sharpie were not curing. On the dowels, which had been stained with regular Minwax red oak, the finish set up just like it's supposed to. On everything else, the finish stayed tacky and never set up.

"Note to self: Do NOT use markers as a stain if finish is to be applied!!"

Rather than strip everything, which would be very messy and mess up the nice stain on the dowels, I am "rubbing out" the tacky areas using tung oil. This seems to get the tacky residue from the poly off and I'm hoping that it will cure where the poly would not.

If this fails, I'll have to strip all of it and just paint the whole flipp'n thing flat black. Boring!!

Bill[/COLOR]
Posted 08/27/2006 10:02PM #1
[COLOR="Purple"]The fix with tung oil didn't seem to be working too well so I pulled out the acetone and gave it all a going over with that. Seems to have gotten all of the tackiness off and a lot of the black is still there. Once I let the whole thing air out for an hour or two, I plan to stain the black with some aniline die, which is what I should have used in the first place. Then I'll spray with poly again and hopefully be done with the USA.
Bill[/COLOR]