Image of the day

Captured by
Ruben Tommasi

Andromeda Galaxy (M31)

My Account

New to Astromart?

Register an account...

Need Help?

Moding a Plastic Meade Focuser FWIW

Started by BoyntonStu, 04/03/2006 07:02PM
Posted 04/03/2006 07:02PM | Edited 04/03/2006 09:12PM Opening Post
The plastic Meade focuser that is on a 114NT is not the smoothest focuser out there (by FAR).

The rack is plastic and the pinion is made of some kind of metal.

Several teeth broke off the rack. Arghh!


Instead of discarding it, I tried an experiment.

1> Filed off all the teeth until I had a smooth surface parallel to the focusing cylinder.

2> Contact cemented a strip of fine Garnett paper for a new 'rack'.

3> Slid a piece of tight-fitting clear plastic tubing over the pinion gear. Extend on both sides, slit the ends lengthwise, and tie off with dental floss to fix in place.

Works like a champ! Smooth as silk. No stepping action.

The hardest part was removing a focusing knob. It was glued in there and impossible to unscrew. Drilled off the screw head, removed the screw with pliers, drilled it out and re-tapped it with an 8-32 tap.

NICE!


I have 2 more focusers to modify. No turning back.

Stu grin
Posted 04/03/2006 11:35PM #1
WE NEED PHOTOS !!!! grin Sounds great Stu, I would like to try that on my starblast I think it has the same plastic focuser as your mead. If you have and photos please post.

Bob

R.A.C. Advisory Committee
NEAIC Co-Chairman
NEAF Advisory Committee

http://www.deer-pond-observatory.com
Warwick, New York
41.15984 -74.2541

[B]Takahashi MT 160

10" F4.5 Newt 8O
R200SS grin
Some kind of 127mm APO

Orion Atlas EQ-G
Losmandy G11 with Gemini
iOptron Mimi Tower
iOptrom Cube Pro

Meade DSI PRO II 8O
SBIG ST-10ME
Image Source 21AU04.AS

Posted 04/04/2006 06:23AM #2
I'll keep that in mind should my NT focuser go ca-ca pooey.

I'm working on a 1 1/4 AJ focuser casting I got from the Surplusshed. Somebody really cocked up the machining job, the rack trough was off line. So I opened a pocket around where the shaft goes through, took a piece of the end of a rubber stopper and ground it down and slipped it on a piece of 1/4" bar stock and pinned it so it wouldn't spin on the shaft. The shaft is locked in the casting with washers and cotter pins and has a couple of knobs for electronic equip. on it for now. When I get her all finitoed I'll snap a couple of pretties and post'um.

The "star" we look at tonight may have exploded millenniums ago. (To progress, we must discern what exists and what does not).