Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Mounting a secondary?

Started by klipy, 10/25/2003 04:34PM
Posted 10/25/2003 04:34PM Opening Post
When mounting the secondary mirror onto the mounting surface with silicone, do you put a bead around the outside edge of the mounting surface or in the center of the mounting surface? How long should you let it "cure" before installing it into the telescope tube? Is it possible to remove the secondary mirror from the silicone if you decide to change mirrors? Thanks for any help.

Bob
Posted 10/25/2003 05:10PM #1
Bob,

Look at page 4 of the Protostar manual.

http://www.fpi-protostar.com/ftp/instman13.pdf

--
Mike
Posted 10/25/2003 06:23PM #2
Three beads will do it. I make sure each squished blob of silicone has contact approximately equal to a 1/4" to 3/8" diameter circle. You could probably do less.

I asked this forum a couple weeks ago if I could take my freshly siliconed secondary out the same day and a few dare-devils said they'd taken theirs out only a few hours after gluing with no problems. I let mine cure for perhaps 14 or 16 hours or so before installing in the scope and it was solid. Normally I'd give it a day or two but I wanted to use it that night.

Removing is a piece of cake: a razor will slice right through it and scrape it from both surfaces.

Attached Image:

P. Lee Stock's attachment for post 72485
Posted 11/02/2003 03:55PM #3
Curing time:

Depends on silicon product. The directions on the tube or package will give the recommended curing times. A warm room helps.

Failover safety-loop:

A little piece of strong thread or fishing line is worth considering.

Silicon-glued to back of the secondary mirror. Tied off to the spider. If the secondary mirror gets loose somehow, the safety-loop saves both mirrors from a nasty early morning.

Cost = 2-cents.