Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

AZ3 1/4-20 adapter lousy?

Started by GLangmead, 05/16/2006 01:48AM
Posted 05/16/2006 01:48AM | Edited 05/16/2006 01:49AM Opening Post
I must not be understanding something. I was given an AZ-3 mount as a gift, and I have a WO Megrez 80 ED. I decided to buy Orion's 1/4-20 adapter and use it with the tripod mounting shoe that comes with the Megrez.

Um, there's no way it will hold the scope on there. The weak point is the way the screw is attached to the tightening wheel -- it's just wedged into a hole! Just tightening it all the way pulls the screw right out of the wheel, let alone jiggling the scope or trying to move it around. I attached a picture of the back of the wheel and the screw on the front -- notice the lack of a nut to hold on to the screw from the back side.

My question is, am I missing something, or is this junk I should exchange for rings instead?

The picture on Orion's site shows that it's held from the back as well but this is not what mine looks like.



Attached Image:

GLangmead's attachment for post 31548
Posted 05/16/2006 03:20AM | Edited 05/16/2006 03:22AM #1
Greg,

On my adapter the bolt is fully threaded. It screws into the thumb wheel. This is only marginally better than yours. I find the bolt backs itself out of the thumb wheel partway and makes it almost impossible to tighten. If I used it more often I might epoxy the bolt into the thumbwheel. I'd go with rings if possible.

Also consider calling Orion and see if they can relace the thumbwheel with an improved/correct part.

Peter
Posted 05/16/2006 11:00AM #2
>>>My question is, am I missing something, or is this junk I should exchange for rings instead?
----

I would exchange the mounting block for some rings. Camera mounting blocks are generally not as secure, they only use on attachment point so the rings are much more solid. Rings also allow you to slide the OTA so you can achieve the best possible balance. With mounting block, normally you are stuck with one position and normally it is not the right one.

In general I am not a big fan of AZ-3 type mounts for astronomical viewing because the scope is not balanced. As you try to move the scope towards the zenith, the scope's weight is no longer centered over the altitude axis and it tries to fall backwards. To overcome this, AZ-3 mounts use friction. A better solution IMHO is a balanced mount such as some of the Unistar mounts, the Telepod etc.

The AZ-3 is essentially a terrestial mount rather than an Astronomical mount.

Jon