Lumenera/Dragonfly/DKM technical quesiton

Started by djanello, 01/12/2007 07:43PM
Posted 01/12/2007 07:43PM Opening Post
Greetings,

I have a question for the high-end webcam gurus on the list, do any of these cameras have ability to be run in parallel, e.g. via an automated/software start mechanism?

I'm looking at building some hardware devices that require very accurate start synchronization of webcam clusters and accurate timestamping of each frame. I don't expect the cameras would have built-in frame-to-frame synchronization like the digital film editors do, so will have to compensate with start accuracy and timestamp information if available.

Thanks,

David A. Janello
www.spreadhunter.com
www.argon-tech.com
Posted 01/14/2007 06:15AM #1
david janello said:

Greetings,

I have a question for the high-end webcam gurus on the list, do any of these cameras have ability to be run in parallel, e.g. via an automated/software start mechanism?

I'm looking at building some hardware devices that require very accurate start synchronization of webcam clusters and accurate timestamping of each frame. I don't expect the cameras would have built-in frame-to-frame synchronization like the digital film editors do, so will have to compensate with start accuracy and timestamp information if available.

Thanks,

David A. Janello
www.spreadhunter.com
www.argon-tech.com

David, the firewire cameras can operate in synchronous mode, if they are on the same bus. I know the Dragonfly Express that I have will do this, and also the cheaper fire-i camera will do it. It's a standard feature of the firewire camera specification, but you'd have to check that the DMK cameras have implemented it.

cheers, Anthony

http://www.acquerra.com.au/astro