Image of the day

Captured by
Lawrence Parchman

Eastern Veil Nebula (NGC 6992) - Wide View

My Account

New to Astromart?

Register an account...

Need Help?

Luminera first light (don't laugh...)

Started by SunSpot51, 06/27/2005 11:52PM
Posted 06/27/2005 11:52PM | Edited 06/27/2005 11:54PM Opening Post
Hi all,

Here is one of 3 images that are from my first light with the Luminera075C camera. The seeing was not good, but I am starting to get a little handle on this camera. I think the quality of the images could be better, even past the seeing but it will take time and lots of questions to those who know more than me. These questions I will post in the Luminera Forum that Paolo created.

Basically this image is a stack of 1500 images out of 2300 shot at 57fps....that's a 40 second Avi!! It was shot with my C925 and 2.5x powermate. I can sure tell the chip is larger from the smaller image. I find that at 57fps it is harder to focus, maybe something I have to get used to. Also, I find that enlarging and/or rotating the image degrades it more than with the Toucam. Won't be until Wednesday evening that I'll image again likely....but I'll stay with it.

Comments welcome!
Paul


Attached Image:

SunSpot51's attachment for post 25244

Paul Maxson
Moderator - CCD Imaging and Processing/Solar System
Celestron C14, Mewlon 250, Orion EON120, ASI120MM, Flea3.
http://www.sunspot51.com
Posted 06/28/2005 12:58AM #1
Hi. I have a question for you guys who use the LU cameras. When you capture at such high frame rate, do you get dropped frames at all? I found it hard not to get dropped frames. What video codec did you use to capture?
Posted 06/28/2005 01:32AM #2
Hi Paul,

Not bad at all for your first one with the Lumenera especially with the size of Jupiter now and the lower altitude, it's been my experience though that it is easier to focus with a fast frame rate.

Thanks,

Wes Higgins
Posted 06/28/2005 10:31AM | Edited 06/28/2005 01:42PM #3
Not to worry Paul: been there, done that smile

It takes a little while getting used to the new camera (lots of new and unknown "thingys" to keep under control cwy ).

However, I must admit I am a little puzzled about the framerate you use: It seems to me a bit high for you aperture and f ratio. I have an 11" and all my images were captured at 15/22 fps (the second higher value refers to the increased rate when ROI is activated) and I find that value OK (I work at appprox. F30). I use higher framerates only while focusing, but even then I never exceed the 30fps limit: there is simply not enough light gathered to afford such a fast shutter speed. The effect of this is that you are then forced to push on the gain in order to have the 220 ADU needed to have a properly exposed frame and this increases the overall noise in the final image.

Wes uses a 60fps but he has an 18" to collect photons 8) . Even Paolo uses 30fps sometimes, but his monochrome camera is way more sensitive than our "bayerized" models.

So, I would advice to try to film at lower framerates to see what comes out. Just my opinion, of course.

Ciao Paul

Luca

www.amun-ra.org
Solar Imaging Website
Posted 06/28/2005 01:31PM #4
Paul,

Looks like a good 1st light image to me, I think in a couple weeks you'll be comfy with the camera/software. Might try what Luca suggested use 30fps. Hey I had to learn my new camera on the road!
Guesss thats why I did'nt get any good images :C

cheers

Mike
Posted 06/28/2005 06:02PM #5
Hi Paul,
At least you are imaging. It is raining here.
Can anyone go through the steps they go through when they first add the camera to the focuser until they image?
Laso, can you give me the URL of the Luminera usergroup Paolo started?
Finally, does the Luminera image in color or do you have to do that RGB thing?

Jim Phillips