DIAL Vernier calipers could be used to measure optimium focus settings for any combination of lenses that should not change afterward unless other diagonals/lenses not previously measured are put in the OTA. Measuring points would be the end of the OTA to the camera adaptor ring or similar. Accuracy could be to 0.001 inch of focus depending on skill of person with tool. For cameras, a shot taken in 0.010 steps will start the zeroing in process before resolving it to 0.001 inch. Accuracy should be far better than any gross focus dial counter or helical focuser for repeatable accuracy. -just-a-thought. -Larry
Blind focusing....Practical?.
Started by barf, 12/05/2002 05:18PM
Posted 12/05/2002 05:18PM
Opening Post
Funding Member