Image of the day

Captured by
Bruce Karbal

VDB 142 Elephant Trunk HOO

My Account

New to Astromart?

Register an account...

Need Help?

A little help please..

Started by gibson57guy, 05/06/2004 08:12PM
Posted 05/06/2004 08:12PM Opening Post
As some may know I had several spiders inside my scope messed up the inside of my lense forcing me to take out the objectives and clean them.. All that is done and everything is back together but something is not right. A star test shows an oblong circle which usually means astigmatism, which leads me to believe I didn't align the two lenses together properly.. ( I tried loosening and tightening the retaining ring which didn't seem to help )

1. Is there an easy way to just rotate the top lense without taking it all apart again? ( Maybe loosen the retaining ring and move with my hand wearing latex gloves?)

2. Is there some type of false star I could set up say 20ft away so I could test and know if at least I'm headed in the right direction?

3. I did collimate so that only one reflection was showing but I did it by adjusting the focuser..

It originally tested with a good circle before I took it all apart...


Any help would be appreciated....
Posted 05/07/2004 02:46AM #1
Tom & Dan,

I took the len's out again.. rotated the top lense 180 degrees ( thinking I probably did this by accident in the first place ). I then replaced them in the cell again and tapped several times to seat properly.

As luck would have it the skies cleared up... Although the atmosphere was shaky ( lots of twinkling going on ) I was able to do a star test to see if I made progress..

As long as I kept the star exactly in the centre of the eyepiece there was very little astigmatism.. yeahhhh success ( grin ).

Jupiter was still a bit fuzzy so I know I have a slight collimation problem yet. But I'll deal with that later..


Thanks again

Mark Visser