NJP-LL Tripod Question

Started by mclemens, 08/10/2006 11:12PM
Posted 08/10/2006 11:12PM Opening Post
I have a Tak NJP Tripod where the previous owner has tapped out the three holes around the top to 5/16" bolts.

Can this tripod still be used for a stock NJP? or, are the 5/16" bolts too large to pass through whatever bolts down on this?

Thanks
Mike

Attached Image:

mclemens's attachment for post 32884
Posted 08/11/2006 08:44AM #1
Mike,

Looking at the bolts that secure the NJP Equatorial Head onto this tripod using these three holes I am a bit confused. The bolts I use are a 10mm x 12.9mm Hex Head and my tripod hasn't been altered. I believe the 10mm bolts are are standard size to secure the NJP Equatorial Head to this tripod. 5/16" is close to an 8mm bolt yet you say the previous owner has tapped these holes out. Please forgive if I have stuffed the maths up. Are you sure that these holes have been tapped out and are 5/16". Not trying to be a pain or finding fault...just trying to help out.