Image of the day

Captured by
Michael Scherman

M17 Swan-Omega Celestron C6 Hyperstar2

My Account

New to Astromart?

Register an account...

Need Help?

Heat Shrink - Stove

Started by web0178230, 09/27/2006 12:51AM
Posted 09/27/2006 12:51AM Opening Post
[COLOR="Purple"]After using a regualr heat gun to heat the shrink on two of my 16 truss poles, I decided to go "old school". The heat gun was taking 20 minutes per pole. Clearly too slow with 14 more poles to go. Soooo...I brought out the antique camp stove and fired it up. Cuts time per pole down to under 10 minutes. If I were to get out the newer stove, I'm sure I could get that time down to 5 minutes but I'd be melting the poles as I went. grin
Bill[/COLOR]

Attached Image:

web0178230's attachment for post 33677
Posted 09/27/2006 03:22AM #1
May I ask where you buy this large heat shrink tubing?
Posted 09/28/2006 05:43AM #2
Bill,
I'm on the final stretch of completeing my own truss pole setup, and I have a couple of questions about the heat-shrink tubing. One, what are the advantages of using heat-shrink tubing vs etching and painting the poles? I can see how it would not scratch off and maybe protect the poles a little better, but is there anything else? Two, where can one obtain long lengths of heat-shrink tubing inexpensivly? Thanks!

Evan
Posted 10/02/2006 01:44AM #3

Hi Bill

Does the heat shrink tubing shrink in its length at all? Or does it just shrink around the pole? The reason I ask is in the picture it is a little longer than the pole.
Posted 01/15/2007 01:19PM | Edited 01/15/2007 01:20PM #4
I just purchased 12 feet of heat shrink from Judy & Randy Cunningham of AstroSystems. In one hour I was able to mark the tubes, cut the heat shrink into eight pieces and apply the stuff to my tubes. I used a Milwaukee heat gun on the high setting and it made **very** quick work out of it! There was no lateral shrinking, so I ended up with the length that was cut. It was actually kind of neat to watch the stuff shrink! I stood the pole on end, started at the top and applied heat from the top down. It is certainly much nicer than the foam pipe insulation I was using - it would slide off, tear, etc, not to mention it being very bulky. The shrink tubing is reasonably lightweight and will stay put.