Image of the day

Captured by
james carter

North American Nebula NGC7000

My Account

New to Astromart?

Register an account...

Need Help?

Is the Canon 10D CMOS active during image transfer

Started by RazorsEdge, 08/09/2004 07:50PM
Posted 08/09/2004 07:50PM Opening Post
Sorry for double posting,
This thread was initially started in the 'Equipment' forum without a reply. I am hoping for better luck here.
The original post:

RAW image transfer into the computer using a Canon 10D takes about 30 seconds. This is the same amount of time I usually allow the chip to cool between images.
Does the chip remain active? Which would mean an additional 30 second buffer; or, am I good to go once the image download is complete?

Thanks.
-Brian
Posted 08/09/2004 08:59PM #1
Brian,

I normally set it for 30 sec delay between images. You don't have to worry about the images completely downloading as it will catch up when the series of images is done.
As for temp problems, unless its say above 65 deg, I wouldn't worry about this. If its warmer a 60 sec or so delay should be good, as well as a fan blowing on the camera.

Mark